![]() Now pair with it 3.6 # pair Īnd you need to connect 3.7 # connect If you have seen the mac of your device 3.5 # scan off To connect to your device the following needs to be done, scanning is a must 3.4 # scan on Now you need to power it on 3.3 # power on Help command is going to give you pretty much ideas what you can do 3.1 # helpĬheck the bluetooth radios with 3.1 # listĪnd select the radio you want to use with 3.2 # selectThere is nice command line utility for managing bluetooth devices: 3# bluetoothctl Although for development, it might be good to see the debug log ofĪnd start the daemon in debug mode and store the log into out.log and console 2.2# /usr/libexec/bluetooth/bluetoothd -d -n 2>&1 | tee out.log ![]() boot/config- maybe the uhid is hardlinked into kernel.Ĭheck that you have deamon running 2# ps ax | grep bluetoothd If still nothing then you maybe do not have the module, check from If not, then issue 1.1# modprobe uhidĪnd verify again. ![]() You must see here a line showing that uhid is loaded. Make sure that system is running as expected 1# lsmod | grep uhid ![]() ![]() Below are some hints for the one who is following this path. However I had little struggle to get things running well. So, anyone who is struggling to get hid over gatt device to run, Linux is an option besides W8. I got my device to work with Linux: the key presses will reach into text editor. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |